Thinkpad T41p and Fedora Core 5

Installed FC5 off all 5 cdroms.
During installation, configured monitor for "LCD 1400×1050"
eth0 was auto-discovered, but not ath0 (wireless).
Get eth0 up: ifconfig eth0 up, route add default gw
vi /etc/resolv.conf, and add line "nameserver"
Downloaded madwifi drivers (.tar.gz) from
Untar’d to tmp dir
Requires kernel srcs! So, ‘yum install kernel-devel-[match kernel version].i686’
yum install gcc (for building madwifi)
cd madwifi_subdir
make install
modprobe ath_pci
ifconfig -a (should see ath0 now)
Load scanner: modprobe wlan_scan_sta
ifconfig ath0 up
iwlist ath0 scan (view APs in the area and which are encrypted)
iwconfig ath0 essid "default"
iwconfig ath0 key <wep key in hex>
dhclient ath0

(this is from the madwifi "newbie howto" doc)

Disabled acpi in kernel boot options (disable suspend/power management)
kernel … acpi=off rhgb quiet

Disabled apmd (suspend results in freeze)
[root@localhost ~]# chkconfig –list| egrep apm
apmd            0:off   1:off   2:on    3:on    4:on    5:on    6:off
[root@localhost ~]# chkconfig apmd off
chkconfig apmd off
[root@localhost ~]# chkconfig –list| egrep apm
apmd            0:off   1:off   2:off   3:off   4:off   5:off   6:off

Change /etc/X11/xorg.conf to read:
Section "Monitor"
        Identifier   "Monitor0"
        VendorName   "Monitor Vendor"
        ModelName    "Generic Laptop Display Panel 1400×1050"
        HorizSync    31.5 – 90.0
        VertRefresh  59.0 – 75.0
        Option      "dpms"

Section "Device"
        Identifier  "Videocard0"
        Driver      "radeon"
        VendorName  "Videocard vendor"
        BoardName   "ATI Radeon Mobility M9"
        Option      "AGPMode" "4"
        Option      "EnableDepthMoves" "on"
        Option      "EnablePageFlip" "on"

Section "Screen"
        Identifier "Screen0"
        Device     "Videocard0"
        Monitor    "Monitor0"
        DefaultDepth     24
        SubSection "Display"
                Depth     24
                Modes    "1400×1050" "1280×1024" "1280×960" "1152×864" "1024×768" "640×480"
                Virtual  0 0

Section "DRI"
        Group        0
        Mode         0666
(end of xorg.conf)

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.